End Panel, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .
-- Left: Remove the windshield washer fluid reservoir. Refer to WASHER FLUID RESERVOIR, REMOVING AND INSTALLING .
-- Right: if equipped, release the retainer -3-.
-- Remove the bracket -1- in the direction of -arrow A-, and disengage downward -arrow B- and remove.
-- Disconnect the connector -2- on the subframe mount control module.
-- Remove the expanding rivets -4-.
-- Remove the guide -3- on the top of the fender end plate from the fender -2-.
-- Remove the end plate -1- forward starting at the bottom.