LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 939 (Exhaust System, Emission Controls (CREC, Cred, CREH)) >> 26 Exhaust System, Emission Controls >> Exhaust Manifold >> Exhaust Manifold, Removing And Installing >> Left Exhaust Manifold, Removing And Installing >> Installing

Left Exhaust Manifold, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following: 

NOTE:

Replace Seal And Self-Locking Nuts After Disassembly.

Coat The Thread On The Nut With Hot Bolt Paste.

-- Position the exhaust manifold with the catalytic converter seal and tighten the nuts. Refer to Figure.

-- Electrical connections and wiring routing. Refer to the appropriate WIRING DIAGRAM.

-- Install the left catalytic converter. Refer to LEFT CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING, ACCESSORY RIBBED BELT .

scientia non olet · About LEMON Manuals