LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 939 (Exhaust System, Emission Controls (CREC, Cred, CREH)) >> 26 Exhaust System, Emission Controls >> Emissions Control >> Catalytic Converter, Removing And Installing >> Right Catalytic Converter, Removing And Installing >> Installing

Right Catalytic Converter, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following: 

NOTE:

Replace Seals And Self-Locking Nuts After Disassembly.

-- Install the right secondary air injection combination valve. Refer to RIGHT COMBINATION VALVE, REMOVING AND INSTALLING .

-- Install the Oxygen Sensor after Three Way Catalytic Converter -G130-. Refer to HEATED OXYGEN SENSOR -G39- /OXYGEN SENSOR AFTER THREE WAY CATALYTIC CONVERTER -G130-, REMOVING AND INSTALLING .

-- Install the right coolant pipe on the transmission. Refer to RIGHT COOLANT PIPE ON TRANSMISSION, REMOVING AND INSTALLING .

-- Install the Throttle Valve Control Module -J338-. Refer to THROTTLE VALVE CONTROL MODULE -J338-, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals