Overview - Secondary Air Injection System
WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Bracket
- For Secondary Air Injection Pump Motor -V101-
- Nut
- 9 Nm
- Bonded Rubber Bushing
- Secondary Air Injection Pump Motor -V101-
- Installed location: in the front of the engine compartment on the right side under the longitudinal member
- Removing and installing. Refer to Secondary Air Injection Pump Motor -V101-, REMOVING AND INSTALLING .
- Checking in Guided Functions , see Vehicle Diagnostic Tester
- Pipe
- For secondary air
- O-Ring
- Always replace
- O-Ring
- Always replace
- Secondary Air Injection Sensor 1 -G609-
- Removing and installing. Refer to Secondary Air Injection Sensor 1 -G609-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Connection Flange
- Bolt
- 9 Nm
- Gasket
- Always replace
- Right Secondary Air Injection Combination Valve
- Installed location: on the front of the cylinder head
- Checking. Refer to SECONDARY AIR INJECTION SOLENOID VALVE, CHECKING .
- Removing and installing. Refer to COMBINATION VALVE, REMOVING AND INSTALLING .
- Vacuum Hose
- Gasket
- Always replace
- Hose
- For secondary air
- To Secondary Air Injection (AIR) combi-valves
- Vacuum Hose
- Left Secondary Air Injection Combination Valve
- Installed location: on the front of the cylinder head
- Checking. Refer to SECONDARY AIR INJECTION SOLENOID VALVE, CHECKING .
- Removing and installing. Refer to COMBINATION VALVE, REMOVING AND INSTALLING .
- Gasket
- Always replace
- Connection Flange
- Seal
- Always replace
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- O-Ring
- Always replace
- Resonator
- Hose
- For secondary air
- Air Filter
- O-Ring
- Always replace