Exhaust System, Installing Without Tension: Procedure

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Align The Exhaust System When Cold.

Vehicles Without Double Clamps Between Center And Rear Mufflers

-- Loosen the screws on the front clamping sleeves.

-- Push the exhaust system far enough forward -arrow- until the pre-load on the retaining loops in front of the center muffler is -a- = 6 to 10 mm.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the clamping sleeve threaded connections evenly.

Vehicles With Double Clamps Between Center And Rear Mufflers

NOTE:

The Center Muffler Also Needs To Be Aligned On Vehicles With Clamping Sleeves Between The Center And Rear Mufflers.

-- Loosen the screws on the front and rear clamping sleeves.

-- Push the exhaust system far enough forward -arrow- until the pre-load on the retaining loops in front of the center muffler is -a- = 6 to 10 mm.

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the front clamping sleeve threaded connections evenly.

-- Push rear part of exhaust system far enough forward -arrow- so that the pretension at rear retaining loops of rear mufflers is -a- = 11 to 15 mm.

Courtesy of AUDI OF AMERICA, LLC

-- Align rear muffler horizontally.

-- Tighten the rear clamping sleeve threaded connections evenly.