LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 938 (Exhaust System & Emission Controls System (Service Information - (CEUC, CRDB, CTGE, CWUB, CWUC)) >> 26 Exhaust System, Emission Controls >> Emissions Control >> Catalytic Converter, Removing And Installing >> Installing

Catalytic Converter, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following: 

NOTE:

Replace The Seals And Self-Locking Nuts.

-- Install the wires. Refer to and the appropriate WIRING DIAGRAM.

-- Install the Heated Oxygen Sensor 2 -G108-. Refer to HEATED OXYGEN SENSOR 2 -G108 - / OXYGEN SENSOR AFTER THREE WAY CATALYTIC CONVERTER -G130-, REMOVING AND INSTALLING .

-- Install the plenum chamber bulkhead. Refer to PLENUM CHAMBER BULKHEAD, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals