LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 936 (Suspension System (Front - Service Information)) >> Front Suspension >> Lower Control Arm And Ball Joint >> Control Arm Ball Bearing, Replacing >> Control Arm Ball Bearing, Replacing, Wheel Bearing Housing Side >> Pressing Out Bonded Rubber Bushing

Pressing Out Bonded Rubber Bushing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
GWWA40-10411Courtesy of AUDI OF AMERICA, LLC

-- Mark the press-in depth on the bonded rubber bushing -1- -arrow-.

Use a waterproof felt-tip pen for marking.

-- Install the special tools as shown in the illustration.

-- Remove the bonded rubber bushing -1- from the control arm -2-.

scientia non olet · About LEMON Manuals