Installing Bonded Rubber Bushing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Transfer the installation depth marking from the old bonded rubber bushing to the new one.

-- Thinly coat the bonded rubber bushing with the Assembly Paste:G 052 109 A2 .

-- Install the bonded rubber bushing -1- into the control arm -2-.

-- Install the special tools as shown in the illustration.

NOTE:

When installing, make sure the bonded rubber bushing does not tilt.

-- Install the bonded rubber bushing -1- into the control arm -2-.

-- Note the installation depth marking when installing -arrow-.

-- Check the press-in depth of the bonded rubber bushing -1- inside the control arm -2-.

Courtesy of AUDI OF AMERICA, LLC

Dimensions -a and b- must be identical.

-- If the dimensions -a and b- are different, adjust the bonded rubber bushing -1-.

-- Install the control arm. Refer to CONTROL ARM, REMOVING AND INSTALLING .