Triple Roller Joint AAR 3300 i, Disassembling
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Clamp drive axle horizontally in vise.
NOTE:
Use vise clamp jaw protectors.
Make sure that drive axle is not damaged.
-- Mark the location of the joint to the drive axle
If they are not marked and are not installed in their previously installed positions, noises may occur later during driving operation.
A water-proof felt pen is well-suited for marking.
-- Open clamps -arrows-.
-- Slide back protective boot.