Roof Grab Handle, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Unclip The Expanding Caps -2 And 3- But Only Up To Their Lock Position (Do Not Pull Them Out All The Way Otherwise The Silicone Brake And Spring And Fall Out And Then The Handle Has To Be Replaced).
-- Place the angled screwdriver -4- in the gap behind the clips -2-.
-- Pivot the angled screwdriver -arrow-, until the clips slides audibly into the rest position.
-- Repeat the procedure on the two clips -3-.
-- Remove the roof grab handle -1- from the body opening.
-- Leave the expanding caps in the rest position in the roof grab handle.