8RF - Advanced Sound System, Bang & Olufsen, from MY 2015
- Two speakers in the left and right front doors
- One speaker on the left and right side of the instrument panel
- Two speakers in the center of the instrument panel
- Two speakers in the left and right rear doors
- One loud speaker on the left and right side of the rear shelf, Sedan
- One speaker in the left and right D-pillars, Avant
- Subwoofer -R11- in the rear shelf, sedan
- Subwoofer -R211- in the spare tire well, Avant
- Digital Sound System Control Module -J525-
There is a sound system with ANC EP1 and without ANC EP0.
- Left Front Midrange Speaker -R103- in center of left front door
- Right Front Midrange Speaker -R104- in center of right front door
- Left Rear Midrange Speaker -R105- in left rear door at top
- Right Rear Midrange Speaker -R106- in right rear door at top
- Left Effects Speaker -R209- inside Rear Shelf, Sedan
- Left Effects Speaker -R209- inside the D-pillar, Avant
- Right Effects Speaker -R210- inside the rear shelf, sedan
- Right Effects Speaker -R210- inside the D-pillar, Avant
- Left Front Treble Speaker -R20- in the instrument panel on the left side
- Left Front Treble Speaker Motor -V344-
- Center Speaker -R208- in the Instrument Panel Center
- Center Speaker 2 -R219- in the Center of the Instrument Panel
- Right Front Treble Speaker -R22- in right instrument panel
- Right Front Treble Speaker Motor -V345-
- Left Rear Bass Speaker -R15- in the bottom of the left rear door
- Right Rear Bass Speaker -R17- in the bottom of the right rear door
- Left Front Bass Speaker -R21- in the bottom of the left front door
- Right Front Bass Speaker -R23- in the bottom of the right front door
- Subwoofer -R11- in the rear shelf, sedan
- Subwoofer -R211- in the spare tire well, Avant
- Interior Microphone -R74-, Microphone Unit in Front Roof Module -R164- in the Front Interior Lamp -W1-
- ANC microphones inside the headliner
- Digital Sound System Control Module -J525- in luggage compartment on left rear side
- MOST Bus
Notes on MOST bus
The optical data bus "MOST bus" is used in addition to the CAN bus.
A fiber-optic cable is used. Fiber optic cables are routed inside corrugated tubes for protection.
Replace the complete fiber-optic cable if possible.
The front surface of the connectors must not be contaminated.
If disconnecting the connectors: Attach the Fiber-Optic Repair Set - Connector Protective Caps :VAS 6223/9 .
When routing fiber-optic cables, make sure not to go below the minimum bending radius of 25 mm. Do not crush or kink the fiber-optic cables.
Repairing fiber optic cables. Refer to FIBER-OPTIC CABLE .