Multimedia Control Head 2 -E499-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn off the ignition and all electrical equipment and remove the ignition key.
-- Fold the rear center armrest downward.
CAUTION:
The surfaces can get scratched very easily.
Carefully tape off all surfaces and sections!
The spring clips -1- attach the Multimedia Control Head 2 -E499- -2- to the rear center armrest.
-- Starting at the back -arrow-, press the Multimedia Control Head 2 -E499- -1- out of the rear center armrest using the :3409 .
-- Make sure that the spring clip -arrow- is tightly secured.
CAUTION:
The surfaces can get scratched very easily.
Carefully tape off all surfaces and sections!
-- Unlock and disconnect the connector on the back of the Multimedia Control Head 2 -E499- -1-.