Lane Change Assistance, Calibrating: Procedure
-- Turn on the :VAS6350/4 at the power switch -3-.
- The green LED -1- must turn on.
If the red LED -2- comes on: Check the :VAS6350/4 .
-- Follow the instructions in the Vehicle Diagnostic Tester display.
During the program sequence, a request is made to switch the :VAS6350/4 from the right to the left side of the :VAS6350A .
-- Turn off the :VAS6350/4 and reposition the calibration tool.
- When installed correctly, the vehicle electrical system voltage wire must be connected at the bottom left of the calibration device (as seen in direction of travel).
Dimension -a- is measured from the upper edge of the calibration device to the floor.
| Model | A6 Sedan (2K1/2K2) A6 Sedan S line (2K7/2K8) S6 Sedan (2K3/2K4) | A6 Avant (2K1/2K2) A6 Avant S line (2K7/2K8) S6 Avant (2K3/2K4) | A6 allroad quattro | RS6 Avant | A6 Sedan e-tron China | |
|---|---|---|---|---|---|---|
| Adjustment dimension height in mm dimension -a- | SWA 1.7 | 810 | 810 | 800 | 810 | |
| SWA 2.0 | 788 | 788 | 806 | 821 | 814 |
-- The indicator on the base of the :VAS6350/4 must align with adjustment dimension on the measuring scale -1- on measuring field -arrow-.
| Model | A6 Sedan (2K1/2K2) A6 Sedan S line (2K7/2K8) S6 Sedan (2K3/2K4) | A6 Avant (2K1/2K2) | A6 Avant S line (2K7/2K8) S6 Avant (2K3/2K4) | A6 allroad quattro | RS6 Avant | A6 Sedan e-tron China | |
|---|---|---|---|---|---|---|---|
| Left adjustment dimension read in mm on the measuring scale -1- | SWA 1.7 | 790 | 790 | 790 | 790 | 790 | |
| SWA 2.0 | 845 | 760 | 836 | 835 | 833 | 845 |
-- Turn on the :VAS6350/4 at the power switch -3-.
- The green LED -1- must turn on.
-- Follow the instructions in the Vehicle Diagnostic Tester display.
-- After calibrating the lane change assistance successfully, end "calibration", switch off the ignition and disconnect the diagnostic connector.