LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 932 (Transmission System (Controls & Housing - Service Information - 8-Speed Automatic - 0BK AWD)) >> 37 Controls, Housing >> Transmission, Removing And Installing >> Transmission Tightening Specifications >> Transmission Mount for the 3.0L TFSI-/3.0L TDI Biturbo-Engine

Transmission Mount for the 3.0L TFSI-/3.0L TDI Biturbo-Engine

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine to Transmission Bolts And Alignment Sleeves -A- (3.0L TFSI And 3.0L TDI Biturbo-Engine)
GWWA37-11081Courtesy of AUDI OF AMERICA, LLC
Item Bolt Nm
1 M10 x 50 1) 65
2 through 6 M12 x 100 2) 30 + 90°
7 M12 x 125 30 + 90°
8, 11 M10 x 60 2) 15 +90°
9 M10 x 75 2) 15 +90°
10 M10 x 95 2) 15 +90°
A Alignment sleeves for centering
  • 1) Attaches the starter to the transmission. Bolt strength rating 10.9. There is no limit to the number of times the steel bolt can be used again.
  • 2) Aluminum bolts may be used two times. Refer to Aluminum Bolts .
scientia non olet · About LEMON Manuals