Overview - SUBFRAME Mount
WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- M10x55 8.8: 40 Nm
- M10x40 10.9: 70 Nm
- Tunnel Crossmember
- Removing and installing. Refer to TUNNEL CROSSMEMBER, REMOVING AND INSTALLING .
- Stop
- For the transmission mount
- Transmission Mount
- Removing and installing. Refer to SUBFRAME MOUNT [For engine(s) CYNB] or SUBFRAME MOUNT [For engine(s) CREC, CREH] or SUBFRAME MOUNT [For engine(s) CTGE, CEUC] or SUBFRAME MOUNT [For engine(s) CPNB] .
- Bolt
- 40 Nm
- Nut
- 20 Nm
- Only remove when the transmission mount must be separated from the transmission support
- Bolt
- 40 Nm
- Transmission Support
- Removing and installing. Refer to SUBFRAME MOUNT [For engine(s) CYNB] or SUBFRAME MOUNT [For engine(s) CREC, CREH] or SUBFRAME MOUNT [For engine(s) CTGE, CEUC] or SUBFRAME MOUNT [For engine(s) CPNB] .
- Bolt
- 20 Nm +90° turn
- Always replace
- Only remove when the transmission mount must be separated from the transmission support
- Nut
- 20 Nm