Tightening Specifications: Installing
WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. At the same time pay attention to the following:
CAUTION:
Danger of causing damage to the transmission.
- Remove all the plugs on the ATF lines and on the transmission that were installed during removal.
- The ATF cooling function will not work and the transmission will be damaged if the plugs are forgotten.
-- Lightly coat the ATF supports with ATF.
-- Insert the ATF line -1- all the way on the ATF supports until the catches are released.
-- In this position push down the quick-release coupling clip.
-- Re-tighten the bolts -arrows- to the tightening specification.