LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 932 (Transmission System (Controls & Housing - Service Information - 8-Speed Automatic - 0BK AWD)) >> 37 Controls, Housing >> Automatic Transmission Fluid (ATF) Circuit >> Automatic Transmission Fluid (ATF) Pipes, Removing And Installing >> Tightening Specifications >> Cleaning

Tightening Specifications: Cleaning

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Pay attention to clean working conditions for the transmission. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- Before installing a replacement transmission, always clean out the ATF cooler and ATF pipes using compressed air (maximum 10 bar (145 psi)).

-- Place the :SMN372500  under the transmission.

NOTE:

If extremely dirty ATF flows out when cleaning using compressed air, flush the ATF cooler and lines using clean ATF.

scientia non olet · About LEMON Manuals