Automatic Transmission Fluid (ATF) Pipes, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
General repair instructions. Refer to GENERAL REPAIR INFORMATION .
Pay attention to clean working conditions for the transmission. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
Seal the open lines and connections with clean plugs from the :VAS6122 .
Check ATF level after replacing ATF pipes. Refer to AUTOMATIC TRANSMISSION FLUID (ATF) LEVEL, CHECKING .
CAUTION:
Danger of causing damage to the transmission.
- Remove all the plugs on the ATF pipes and on the transmission that were installed during removal.
- The ATF cooling function will not work and the transmission will be damaged if the plugs are forgotten.
-- Place the :SMN372500 under the transmission.
Vehicles through MY 2014
-- Remove the clamps -1 and 4- and disconnect the ATF lines.
-- Remove the bolts -arrows- and the ATF lines.
-- Seal the open lines and connections with clean plugs from the :VAS6122 .