LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 930 (Transmission System (Controls & Housing - Service Information - 7-Speed Dual Clutch - 0CK)) >> 34 Controls, Housing >> Transmission, Removing And Installing >> Transmission, Installing >> Procedure >> Vehicles with 6-Cylinder TDI Engine

Vehicles with 6-Cylinder TDI Engine

WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
GWWA13-11006Courtesy of AUDI OF AMERICA, LLC

-- Remove the :T40170  .

GWWA10-10826Courtesy of AUDI OF AMERICA, LLC
NOTE:

The vibration damper -1- must rest flat on the drive plate before screwing in the first bolt.

GWWA37-11222Courtesy of AUDI OF AMERICA, LLC

-- Install the first bolt -arrow-, tighten to 10 Nm, loosen and then tighten to 2 Nm (hand-tight).

-- Remove the :T40169  .

GWWA10-10825Courtesy of AUDI OF AMERICA, LLC

-- Tighten the flywheel to the drive plate as follows: