LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 930 (Transmission System (Controls & Housing - Service Information - 7-Speed Dual Clutch - 0CK)) >> 34 Controls, Housing >> Transmission, Removing And Installing >> Transmission, Installing >> Procedure >> Vehicles with 4-Cylinder TDI Engine

Vehicles with 4-Cylinder TDI Engine

WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
GWWA34-11237Courtesy of AUDI OF AMERICA, LLC

-- Loosen the torque support bolts -1-.

-- Lift the transmission and install the tunnel crossmember. Refer to OVERVIEW - SUBFRAME MOUNT .

-- Adjust the torque support -2- and tighten. Refer to SUBFRAME MOUNT [For engine(s) CYNB] or SUBFRAME MOUNT [For engine(s) CPNB] .

All Vehicles 

-- Install the tunnel crossmember. Refer to OVERVIEW - SUBFRAME MOUNT .

-- Lower the :VAS6931  with the :T40173  and set aside.

CAUTION:

Vibrations or rattling noises when driving may be a result of a tightly bolted flywheel.

  • The sequence of steps must always be followed in order.
  • The flywheel must rest flat on the drive plate when screwing in the first bolt.

-- Turn the crankshaft on the vibration damper 360° in the direction of engine rotation -arrow-.

GWWA10-11424Courtesy of AUDI OF AMERICA, LLC
scientia non olet · About LEMON Manuals