Vehicle with 6-Cylinder Engine (Six Bolts)

WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Turn the crankshaft on the vibration damper 180° in the direction of engine rotation, install bolt -4- and tighten to 60 Nm.

-- Turn the crankshaft another 60° the direction of engine rotation, install bolts -5 and 6- and tighten to 60 Nm.

-- Turn the crankshaft another 60° in the direction of engine rotation and tighten bolt -1- to 60 Nm.

-- Turn the crankshaft another 60° the direction of engine rotation, install bolts -2- and -3- and tighten to 60 Nm.

All Vehicles

Courtesy of AUDI OF AMERICA, LLC

-- Tighten then engine bolts to the transmission accessible from underneath.

-- Install the cover -1-.

Install in reverse order of removal. Note the following:

-- Install selector lever cable. Refer to SELECTOR LEVER CABLE, REMOVING AND INSTALLING .