Overview - Transmission Fluid Circuit
WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
- Sealing Plug
- For the ATF check and fill hole
- Tightening Specification, refer to -item 1- Sealing Plug (Drain and Sealing Plug ).
- Sealing Plug
- 35 Nm
- For transmission fluid inspection and fill hole
- Replace after removing
- Transmission Electric Pump 2 -V553- (Transmission Fluid Pump)
- With seal welded on
- Must be removed for draining the transmission fluid (MTF)
- Replace the transmission fluid pump if the seal is damaged.
- Removing and installing. Refer to TRANSMISSION FLUID PUMP, REMOVING AND INSTALLING .
- Bolt
- 3 Nm +90°
- Replace after removing
- Drain Plug
- For the ATF
- Tightening Specification, refer to -item 5- (OVERVIEW - ATF CIRCUIT).