Selector Lever Handle, Removing And Installing: Installing
-- Turn the locking ring all the way in direction of -arrow-.
- The markings -a and b- are not above one another.
- The locking button points in the drive direction.
The selector mechanism could get damaged.
- The locking button -2- on the selector lever handle must be extended when installing. If the button should get pushed in unintentionally while the handle is removed, then it must be brought back into its installation position. Refer to BUTTON IN HANDLE, MOVING INTO INSTALLATION POSITION .
- If the locking button is pushed in while the handle is being installed, destroy the handle and the selector mechanism pull rod -1-.
-- Press the selector lever handle -3- onto the lever completely without touching the locking button -2-.
- When doing this, the handle must engage into ring groove of the selector lever.
-- Turn the locking ring all the way in direction of -arrow-.
- It must be possible to turn the locking ring; press the handle -2- on again if necessary.
- The markings -a and b- are above one another.
If the locking ring was turned, then the handle is not properly locked. Only then may the locking button be pressed on the handle.
The locking button may have an increased resistance to pressure when it is pushed the first time after installing the handle.
-- Press the locking button -1- in the selector lever handle.
-- Move the selector lever button mechanism through "R" and "S" to perform the function test.
- If the selector lever positions cannot be reached, remove the handle again.
-- Pull the selector lever boot downward and attach it to the Multimedia System Control Head -E380-.