LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 930 (Transmission System (Controls & Housing - Service Information - 7-Speed Dual Clutch - 0CK)) >> 34 Controls, Housing >> Selector Mechanism >> Emergency Release From P >> Procedure

Emergency Release From P: Procedure

WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
GWWA34-10679Courtesy of AUDI OF AMERICA, LLC
NOTE:

The handle on the selector lever is not shown in the illustration. It is not necessary to remove the handle in order to unlock the selector mechanism when it is in "P".

-- Remove the front ashtray insert, if equipped.

-- Pry out the cap -1- inside the ashtray housing with a screwdriver in direction of -arrow-.

-- Press the cylinder in direction of -arrow- on the Shift Lock Solenoid -N110-, for example using the screwdriver from the vehicle tool kit, through the center opening in the ashtray housing and at the same time, shift the selector lever out of "P" while pressing the button on the selector lever.

GWWA37-10757Courtesy of AUDI OF AMERICA, LLC
NOTE:

This unlocks the locking lever -1- when the selector lever is in "P".

If the cylinder -arrow- on the Shift Lock Solenoid -N110- is covered by insulation or a wire, then move the insulation or the wire to the side.