LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 929 (Exterior Trim System (Service Information)) >> Exterior Equipment >> Spoiler >> Spoiler, Removing And Installing >> Roof Edge Spoiler, Removing And Installing

Roof Edge Spoiler, Removing And Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
GWWA55-10794Courtesy of AUDI OF AMERICA, LLC
  1. Roof Edge Spoiler
    • Removing
    • Remove the rear lid trim

      -- Remove the nuts -4- and bolts -5-.

      -- Disconnect the connector from the brake lamp.

      -- Unclip the clip -2- from the outside one after the other.

    • Installing

      -- Install in reverse order of removal. Push the clips all the way into the rear lid.

  2. Clip
  3. Rear Lid
  4. Nut
    • 4 Nm
  5. Bolt
    • 2.5 Nm
scientia non olet · About LEMON Manuals