Cover, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Check the grommets -1- for damage.
-- Clean the adhesive surface on the body with Cleaning Solution :D 009 401 04 .
-- Remove the protective films from the adhesive tape -1, 2 and 3-.
-- Place the cover -4- on the fender to do so press the securing tabs in the grommets.
-- Press the cover on the entire length of the fender.
- Vehicle resting time is at least 2 hours at room temperature.