LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 928 (Fuel System (Diesel - General & Service Information - CPNB - 1 Of 2)) >> 23 Diesel Fuel Injection >> Intake Manifold >> Intake Manifold, Removing And Installing >> Installing

Intake Manifold, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following: 

NOTE:

Replace the seals

The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

Secure all hose connections with hose clamps of the same type as those equipped by the factory, refer to the Parts information.

To mount the air guide hoses on their connectors securely, spray the bolts on the used clamps with rust remover before installing.

scientia non olet · About LEMON Manuals