Fuel Rail, Removing And Installing: Notes
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Pry Lever :80-200
- Torque Wrench 1331 5-50Nm :VAG1331
- Torque Wrench 1331 Insert - Reversible Ratchet :VAG1331/1
- Union Nut Socket :T40055
- Torque Wrench 1331 Insert - Open Jaw - 17mm :VAG1332/6
-- Remove the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Free up the wiring harness and hoses on the wiring guide -1- using the Pry Lever :80-200 .
-- Pull coolant hose back -arrow-.
-- Remove the bolts -2 and 3- and move the wiring guide to the rear.
-- Open the union nuts from the respective fuel rail that must be removed.
NOTE:
-Left arrow- for the cylinder bank 1 fuel rail
-Right arrow- for the cylinder bank 2 fuel rail