Engine Front
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Oil Level Thermal Sensor -G266-
- Removing and installing, refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .
- Map Controlled Engine Cooling Thermostat -F265-
- Removing and installing, refer to Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING .
- Oil Temperature Sensor 2 -G664-
- Component location, refer to Removing,[See Third Graphic]
- Removing and installing, refer to Oil Temperature Sensor 2 -G664-, REMOVING AND INSTALLING .
- Oil Pressure Switch -F22-
- Removing and installing, refer to Oil Pressure Switch -F22- / Reduced Oil Pressure Switch -F378-, REMOVING AND INSTALLING .
- Reduced Oil Pressure Switch -F378-
- Removing and installing, refer to Oil Pressure Switch -F22- / Reduced Oil Pressure Switch -F378-, REMOVING AND INSTALLING .
- EGR Cooler Switch-Over Valve -N345-
- Removing and installing, refer to appropriate service information. .
- Intake Flap Motor -V157-
- Overview, refer to OVERVIEW - INTAKE MANIFOLD .
- Throttle Valve Control Module -J338-
- Overview, refer to OVERVIEW - INTAKE MANIFOLD .
- Engine Temperature Control Sensor -G694-
- Component location, refer to Engine Temperature Control Sensor -G694-:
- Oil Pressure Regulation Valve -N428-
- Component location, refer to appropriate service information.
- Removing and installing, refer to Oil Pressure Regulation Valve -N428-, REMOVING AND INSTALLING .
- Fuel Pump Control Module -J538-
- Component location, refer to appropriate service information.
- Reducing Agent Injector -N474-
- Only installed on vehicles with a Selective Catalytic Reduction (SCR) catalytic converter
- Component location, refer to appropriate service information.
- Removing and installing, refer to appropriate service information. .
- NOx Sensor Control Module 2 -J881- and NOx Sensor 2 -G687-
- Only installed on vehicles with a SCR catalytic converter
- Component location, refer to appropriate service information.
- Removing and installing, refer to appropriate service information. .
- NOx Sensor Control Module -J583- with NOx Sensor -G295-
- Only installed on vehicles with a SCR catalytic converter
- Component location, refer to appropriate service information.
- Removing and installing, refer to appropriate service information. .
- Reducing Agent Metering System Control Module -J880-
- Only installed on vehicles with a SCR catalytic converter
- Exhaust Gas Temperature Sensor 4 -G648-
- Only installed on vehicles with a SCR catalytic converter
- Component location, refer to appropriate service information.
- Removing and installing, refer to appropriate service information. .
- Exhaust Gas Temperature Sensor 2 -G448-
- Only installed on vehicles with a SCR catalytic converter
- Component location, refer to appropriate service information.
- Removing and installing, refer to Exhaust Gas Temperature Sensor 2 - G448-, REMOVING AND INSTALLING .
- Particulate Sensor -G784-
- Only installed on vehicles with a SCR catalytic converter
- Component location, refer to appropriate service information
- Removing and installing, refer to appropriate service information. .
- -1- inside the plenum chamber on the left side.
- Inside the accelerator pedal module
NOTE:
The Accelerator Pedal Position Sensor -G79- and the Accelerator Pedal Position Sensor 2 -G185- are part of the accelerator pedal module and cannot be replaced separately.
Removing and installing, refer to appropriate service information. .
- Inside the footwell at the brake pedal
Removing and installing, refer to appropriate service information. .
- The Fuel Pump Control Module -J538- -arrow- is level with the bench seat on the right side between the floor panel and the fuel tank.
NOTE:
The floor panel is shown cut open in the illustration.
Removing and installing, refer to appropriate service information. .
- -2- in the rear and on the right side of the engine.
- -2- on the cylinder head cover on the cylinder bank 1 (right).
- -2- in the high pressure pump.
- -2- on left air guide pipe in the engine compartment.
Removing and installing, refer to TURBOCHARGER .
- -1- on left front cylinder block.
Removing and installing, refer to appropriate service information. .
Removing and installing, refer to appropriate service information. .
Removing and installing, refer to appropriate service information. .
- Exhaust Gas Temperature Sensor 3 -G495-
- Exhaust Gas Temperature Sensor 2 -G448-
- NOx Sensor -G295-
- Heated Oxygen Sensor -G39-
- Exhaust Gas Temperature Sensor 2 - G448- connector
- Exhaust Gas Temperature Sensor 3 -G495- connector
- Heated Oxygen Sensor -G39- connector
- NOx Sensor Control Module -J583- connector
- NOx Sensor -G295-
- NOx Sensor Control Module -J583-
- NOx Sensor Control Module 2 -J881- connector
- NOx Sensor 2 -G687-
- NOx Sensor Control Module 2 -J881-
- Particulate Sensor -G784- connector
- Particulate Sensor -G784-
- Particulate Sensor -G784- control module