LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 927 (Crankshaft, Cylinder Block- CLAB, CLAA, CDUC, CGQB, CKVB, CKVC, CDUD, CPNB, CTCB, CTCC, CVUA, CVUB) >> Crankshaft, Cylinder Block >> Piston And Connecting Rod >> Connecting Rods, Checking Radial Clearance

Connecting Rods, Checking Radial Clearance

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required 

-- Remove the connecting rod bearing cap. Clean the bearing cap and journal.

-- Place the Plastigauge® over the entire width of the bearing journal or into the bearing shells.

-- Place connecting rod bearing cap and fasten with the old bolts -Item 1-  OVERVIEW - PISTON AND CONNECTING ROD, do not turn the crankshaft.

-- Install the connecting rod bearing cap.

-- Compare width of Plastigauge® with calibrated scale.

Radial clearance: 

-- Replace connecting rod bolts.

scientia non olet · About LEMON Manuals