LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 927 (Crankshaft, Cylinder Block- CLAB, CLAA, CDUC, CGQB, CKVB, CKVC, CDUD, CPNB, CTCB, CTCC, CVUA, CVUB) >> Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Vibration Damper, Removing And Installing >> Vibration Damper, Removing And Installing, Vehicles Without Torque Support >> Installing

Vibration Damper, Removing And Installing, Vehicles Without Torque Support: Installing

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following: 

NOTE:

Replace the bolts that were tightened with an additional turn.

Replace the shim.

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals