LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 879 (Seating System) >> Diagnosis And Testing >> Seating >> Pinpoint Tests >> Pinpoint Test An : DTC B19A7 >> Pinpoint Test An : DTC B19A7

Pinpoint Test An : DTC B19A7

WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: When taking measurements at Front Seat Climate Control Module (SCME) harness connectors, do not insert the electrical probes into the female connector pins. Inserting the probes into connector pins can cause intermittent or open electrical connections after reassembly resulting in Diagnostic Trouble Codes (DTCs) and system failure. Touching the tip of these connector pins is recommended instead.
NOTE: The airbag warning indicator illuminates when the correct RCM fuse is removed and the ignition is ON.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

  1. AN1 CHECK THE CUSHION TED BLOWER SPEED CONTROL CIRCUIT FOR A SHORT TO GROUND

    • Ignition OFF.
    • Disconnect: Driver Seat Side Airbag C3051.
    • Disconnect: Passenger Seat Side Airbag C3052.
    • Disconnect: Front Seat Climate Control Module (SCME) C3265C.
    • Disconnect: Driver Seat Cushion TED C3035.
    • Measure the resistance between Front Seat Climate Control Module (SCME) C3265C-11 , circuit RHS03 (GY/OG), harness side and ground.
    1. GFD137467Courtesy of FORD MOTOR COMPANY

    Is the resistance greater than 10, 000 ohms? 

    Yes  GO to  AN2.
    No  REPAIR the circuit. CLEAR the DTCs. REPEAT the self-test. DISCONNECT the battery ground cable. CONNECT driver seat side airbag C3051 and passenger seat side airbag C3052. REPOWER the SRS. REFER to Supplemental Restraint System .
  2. AN2 CHECK THE CUSHION TED BLOWER SPEED CONTROL CIRCUIT AND BLOWER GROUND CIRCUIT FOR A SHORT TOGETHER

    • Measure the resistance between Front Seat Climate Control Module (SCME) C3265C-11 , circuit RHS03 (GY/OG), harness side and C3265C-15 , circuit CHS03 (GN/BN), harness side.
    1. GFD137468Courtesy of FORD MOTOR COMPANY

    Is the resistance greater than 10, 000 ohms? 

    Yes  INSTALL a new cushion TED. REFER to Seat Cushion Thermo-Electric Device . CLEAR the DTCs. REPEAT the self-test. If the DTC is retrieved again, INSTALL a new Front Seat Climate Control Module (SCME). REFER to Dual Climate Controlled Seat Module (DCSM) . CLEAR the DTCs. REPEAT the self-test. DISCONNECT the battery ground cable. CONNECT driver seat side airbag C3051 and passenger seat side airbag C3052. REPOWER the SRS. REFER to Supplemental Restraint System .
    No  REPAIR the circuits. CLEAR the DTCs. REPEAT the self-test. DISCONNECT the battery ground cable. CONNECT driver seat side airbag C3051 and passenger seat side airbag C3052. REPOWER the SRS. REFER to Supplemental Restraint System .