Removal And Installation
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The roof opening panel must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof opening panel has been removed from the roof opening panel assembly, a new roof opening panel motor/module has been installed or when a new roof opening panel assembly has been installed. For additional information, refer to Roof Opening Panel Motor Initialization .
- 1.
Remove the roof opening panel glass. For additional information, refer to Roof Opening Panel Glass .
- 2.
Remove the 2 trough guide retaining screws and the trough from the trough guide assembly.- To install, tighten to 1 Nm (9 lb-in).
- 5.
Slide the trough guide back to the slot (approximately 15 mm [0.6 in]) cut in track.- Pull the front of the guide up.
- Holding the guide rod, gently rock the guide side to side while pulling the guide forward until the guide is fully out of the track.
- 6.
Inspect the trough guide assembly for damage. If damage is found, inspect the track for broken pieces and remove them.
- 7.
To install, reverse the removal procedure.- Align the roof opening panel. For additional information, refer to Roof Opening Panel Alignment .
- Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization .