Removal And Installation
WARNING: This page is about a different car, the 2017 Lincoln Navigator and 2017 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- 1.
Remove the rear door trim panel. For additional information, refer to
Interior Trim and Ornamentation
.
- 2.
NOTE:
There are 2 tabs on the opposite side not shown in the illustration.
NOTE:
LF shown, LR and RR are similar.
Unlock the 4 tabs and remove the window control switch from the door trim panel.
 Courtesy of FORD MOTOR COMPANY
|
- 3.
Position aside the rear door weathershield.
 Courtesy of FORD MOTOR COMPANY
|
- 4.
Connect the window control switch.
- 5.
Raise or lower the window glass as necessary to access the window glass clamp bolts.
- 6.
Remove the inside glass weatherstrip.
 Courtesy of FORD MOTOR COMPANY
|
- 7.
Remove the rear door glass channel bolt.
- To install, tighten to 11 Nm (97 lb-in).
 Courtesy of FORD MOTOR COMPANY
|
- 8.
Loosen the window glass clamp bolts.
- To install, tighten to 11 Nm (97 lb-in).
- 9.
Tape the window in position, then lower the window regulator downward.
- To install, raise the window regulator approximately 2.54 cm (1.0 in) from the full UP position. Then, while manually pushing the glass into the rear channel, raise the window regulator to the full UP position.
- 10.
Lift the window glass out of the door.
- 11.
To install, reverse the removal procedure.