Removal And Installation

WARNING: This page is about a different car, the 2016 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: All seatbelt components must be inspected and corrected as part of any collision repair. Inspect all seatbelt components as prescribed by Safety Belt Inspection and Repair After a Collision . Failure to follow this instruction may result in incorrect operation of the seatbelt system and increase the risk of serious personal injury or death in a crash.

1.

Remove the third row 40 percent seat. For additional information, refer to Seating .

2.

Remove the bolt and safety belt buckle.
- To install, tighten to 40 Nm (30 lb-ft).

3.

NOTE: Make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

To install, reverse the removal procedure.

4.

Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test in Component Test .