Fuel Tank Lock Switch F314 , checking
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
The Fuel Tank Lock Switch F314 consists of a reed contact on fuel filler tube and a fuel tank cap with an embedded magnet. If fuel tank cap is not fully screwed on, the reed contact switches on an indicator in instrument cluster.
Special tools, testers and auxiliary items required
- Portable multimeter V.A.G 1526 C
- Connector test set V.A.G 1594 C
- If indicator is lit, check the following points in order:
- Fuel tank cap is completely screwed on.
- Correct fuel tank cap (Identification: Threads are gray in color).
- Switch - arrow - at fuel filler tube is fully inserted.
- Electrical malfunction in switch.
- Wiring connection to instrument cluster is faulty (check according to schematics).
Fuel Tank Lock Switch F314 , checking electrical
- Remove rear seat bench →
- 72 - SEAT - FRAMES
- 72 - SEAT - FRAMES for BODY INTERIOR - CABRIOLET
- Unbolt cover for right locking flange - arrows -.
- Disconnect electrical connector - 2 -.
NOTE:
- Ignore - 1 -.
- Connect hand multimeter V.A.G 1526 between terminal - 1 - and - 2 - for resistance measurement.
| Fuel tank cap | Specified value |
|---|---|
| Screwed on tight | Less than 1 Ω |
| Not or incorrectly screwed on | ∞ Ω |
If specifications are not obtained:
- Remove right rear wheel housing liner →
- 66 EXTERIOR EQUIPMENT
- 66 - EXTERIOR EQUIPMENT for BODY EXTERIOR - CABRIOLET
- Replace Fuel Tank Lock Switch F314 - arrow - , thereby unclipping and clipping in the switch and electrical wiring at fuel filler tube.