LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (4.2L - Engine Mechanical, Engine Code(S): BNS) >> 13 - Engine - Crankshaft, Cylinder Block >> Belt pulley side, servicing operations >> Ribbed belt, removing and installing >> Installing

Ribbed belt, removing and installing: Installing

WARNING: This page is about a different car, the 2008 Audi RS 4 and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Placing Ribbed Belt Over Belt Pulley In Specified Sequence
GW00018136Courtesy of VOLKSWAGEN UNITED STATES, INC.
  1. Generator
  2. Ribbed belt
  3. Idler roller
  4. Vibration damper
  5. Tensioning roller
NOTE:
  • When installing the ribbed belt, make sure it is seated correctly on the pulleys.

The rest of installation is in reverse order of removal, note the following:

scientia non olet · About LEMON Manuals