LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 694 (2.0L - Ignition System - Engine Code(S): CAEB, CHJA, CPMA & CPMB (As Of 08.2014)) >> Ignition System >> Ignition System >> Engine Speed Sensor -G28-, REMOVING AND INSTALLING >> Removing

Engine Speed Sensor -G28-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the connector on the Engine Speed Sensor - G28- -2- with the Elbow Assembly Tool T10118.

Fig 1: Engine Speed (RPM) Sensor And Bolt
GWWA24-10612Courtesy of AUDI OF AMERICA, LLC
NOTE:

To release the connector without the Elbow Assembly Tool T10118, push the connector against the engine speed sensor and simultaneously lift up on the release tab with a thin wire hook.

-- Remove the bolt -1-.

scientia non olet · About LEMON Manuals