Removing And Installing

Fig 1: Identifying Circlip -1- In Flange Shaft Groove

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left flange shaft, refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Remove the locking ring -1- from the flange shaft.

-- Remove the ball bearing -A- from the flange shaft

Fig 2: Ball Bearing

Courtesy of AUDI OF AMERICA, LLC

-- Lay the bracket -B- on the ball bearing.

Fig 3: Identifying Ball Bearing, Installation

Courtesy of AUDI OF AMERICA, LLC

• Bracket installed position: the writing faces the flange

-- Install the new ball bearing -A- on the flange shaft all the way.

-- Install the new circlip -1- in the flange shaft groove.

Fig 4: Identifying Circlip -1- In Flange Shaft Groove

Courtesy of AUDI OF AMERICA, LLC

-- Install the left flange shaft, refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .