Left/Right Parking Brake Motor -V282- / -V283-, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
-- Release the parking brake.
-- Turn off the ignition.
NOTE:
Ignition must be switched off for at least 30 seconds before disconnecting the connector.
-- Remove affected rear wheel, refer to WHEEL, CHANGING AND MOUNTING .
-- Clean the entire area around the connector and actuator/brake caliper.
-- Disconnect actuator connector -1-.
-- Remove both actuator bolts -1-.
-- Remove the actuator in the direction of the -arrow-
-- Remove sealing ring with a suitable tool.
Make sure that ring groove of the seal and contact surface of parking brake actuator do not become damaged.
NOTE:
Do not use any tools with sharp edges.
-- Clean ring groove and contact surfaces if dirty. Only use brake cleaner.