LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 652 (2.0L - Crankshaft & Cylinder Block - Engine Code(S): CAEB, CHJA, CPMA & CPMB) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Vibration Damper, Removing And Installing >> Vibration Damper, Removing And Installing Non-Hybrid Vehicles >> Notes

Vibration Damper, Removing And Installing Non-Hybrid Vehicles: Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required 

NOTE:

The vibration damper bolt -A- connects the vibration damper -1- timing chain connection -2- and the crankshaft -3-. Before removing the bolt, the chain sprocket must be secured to the crankshaft as described as follows.

Fig 1: Locating Vibration Damper Bolt
GWWN13-10588Courtesy of AUDI OF AMERICA, LLC
scientia non olet · About LEMON Manuals