Auxiliary Components Bracket, Removing And Installing, Non-Hybrid Vehicles With All Engine Codes Except CDZA: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace any bolts that were tightened with an additional turn.

Replace the O-rings and seals.

The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

Secure all hose connections with hose clamps of the same type as those equipped by the factory .

In order to be able to securely mount the air guide hoses on their connectors, spray the screws on the previously used clamps with a rust remover.

-- Coat the O-rings -4- with coolant additive. For the correct coolant, refer to Parts .

Fig 1: Accessory Assembly Bracket, Coolant Pump Housing, Connection And O-Rings

Courtesy of AUDI OF AMERICA, LLC

-- Install the connection -2- into the coolant pump housing -3-.

-- Press the accessory assembly bracket -1- onto the connection, mount the bolts and tighten to tightening specification, refer to Figure.

-- Install the oil filter, refer to 4-CYLINDER 2.0 TFSI GASOLINE ENGINE .

-- Install the power steering pump, refer to POWER STEERING PUMP, REMOVING AND INSTALLING .

-- Install the A/C compressor, refer to A/C COMPRESSOR, REMOVING AND INSTALLING ON BRACKET, MECHANICALLY-DRIVEN A/C COMPRESSOR .

-- Install the generator, refer to GENERATOR, REMOVING AND INSTALLING .

-- Install the ribbed belt, refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Install oil dipstick guide tube, refer to OVERVIEW - TIMING CHAIN COVER .

-- Install the After-Run Coolant Pump -V51-, refer to After-Run Coolant Pump -V51-, REMOVING AND INSTALLING, NON-HYBRID VEHICLES WITH ALL ENGINE CODES EXCEPT CDZA .

-- Install the air guide hose, refer to OVERVIEW - CHARGE AIR SYSTEM .

NOTE:

Do not reuse used coolant.

-- Fill the coolant, refer to COOLANT, DRAINING AND FILLING, NON-HYBRID VEHICLES => Filling .

-- Check the oil level, refer to ENGINE OIL LEVEL, FILLING AND CHECKING .