Overview - Timing Chain Cover: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Replace
- Tightening specification and sequence, refer to Figure.
- Crankshaft Shaft Seal, Transmission Side
- Replacing, refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
- Bolt
- Replace
- Tightening specification and sequence, refer to Figure.
- Alignment Sleeve
- Quantity: 2
- Threaded Pin
- Tightening specification, refer to Figure.
- Left Cylinder Head Gasket
- Left Timing Chain Cover
- Removing and installing, refer to LEFT AND RIGHT TIMING CHAIN COVERS, REMOVING AND INSTALLING .
- Bracket
- For wiring harness
- Bolt
- Replace
- Tightening specification and sequence, refer to Figure.
- Lower Timing Chain Cover
- Removing and installing, refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .
- Seals
- Replace
- Bolt
- Tightening specification and sequence, refer to Figure.
- Bracket
- For the connectors
- Bolt
- Replace
- Tightening specification and sequence, refer to Figure.
- Right Timing Chain Cover
- Removing and installing, refer to LEFT AND RIGHT TIMING CHAIN COVERS, REMOVING AND INSTALLING .
- Right Cylinder Head Gasket
- Alignment Sleeve
- Quantity: 2
- Bolt
- Tightening specification and sequence, refer to Figure.
- Engine Speed Sensor -G28-
- Removing and installing, refer to Engine Speed Sensor -G28-, REMOVING AND INSTALLING .
- Bolt
- Tightening specification, refer to OVERVIEW - IGNITION SYSTEM .