Temperature Sensor after Hybrid Battery Evaporator -G757-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn off the ignition.
-- Remove the luggage compartment floor covering. Refer to LUGGAGE COMPARTMENT FLOOR PANEL, REMOVING AND INSTALLING , also see OVERVIEW - LUGGAGE COMPARTMENT FLOOR .
-- Bring the battery cooling module in the service position. Refer to BATTERY COOLING MODULE, BRINGING INTO SERVICE POSITION .
-- Disconnect the connector -1-.
-- Loosen the Temperature Sensor after Hybrid Battery Evaporator -G757- out of the retainer by moving it back and forth -arrows- and then remove it.