After-Run Coolant Pump -V51-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2009 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Noise Insulation Panels

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Risk of scalding due to hot steam and hot coolant.

The coolant system is under pressure when the engine is warm.
Reduce pressure by covering coolant reservoir cap with a cloth and carefully opening.

-- Open the coolant reservoir cap.

-- Remove the front noise insulation -1-. Refer to OVERVIEW - NOISE INSULATION .

-- Remove screw -1- and disconnect harness connector -2-.

Fig 2: Identifying After-Run Coolant Pump (If Equipped)

Courtesy of AUDI OF AMERICA, LLC

-- Place the Shop Crane - Drip Tray VAS6208 under engine.

-- Remove the After-Run Coolant Pump -V51- from the coolant hoses -arrows-.