Cylinder Bore, Checking

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Cylinder Dial Bore Gauge - VAS6078-

NOTE: Risk of Damaging the Cylinder Bore Surface through Incorrect Handling.

Never handle the cylinder bore with service equipment (drilling, honing, lapping).

Using a -VAS6078- measure in a diagonal sequence at three positions transversely -A- and longitudinally -B-.

Courtesy of

Deviation from specified size: maximum 0.08 mm

Dimension	Cylinder Bore Diameter
Standard dimension	82.51 mm

NOTE: A shadow or a shiny spot on the wall of the cylinder does not mean the cylinder bore is damaged as long as the cross-lapping is still visible.

The cylinder bore must not be measured when the cylinder block is mounted on the -VAS6095A- because the measurements may be incorrect.