Sub-Assembly Bracket, Removing and Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi A4 Quattro, 2014 Audi A4 Quattro, and 2013 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- Replace the bolts that were tightened with an additional turn after removing them.
- Replace the O-ring and seals after removing.
- Used coolant cannot be used again.
- Coat the new O-rings -4- with coolant additive.
- Insert the connection -2- into the coolant pump housing -3-.
- Slide the sub-assembly bracket -1- onto the connection and then install and tighten the bolts.
- Install the oil filter. Refer to ENGINE OIL, EXTRACTING AND REPLACING OIL FILTER .
There are additional procedures depending on the model. Refer to Sub-Assembly Bracket, Removing and Installing .