3. Check the Closing Locks - Vehicles with Keyless Stop and Start Systems
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
-- Press the Access/Start Authorization Button -E408- briefly to get "ignition on".
-- Do not move the selector lever into "P" but rather, for example, into "N".
-- Turn off the ignition.
- A warning message must appear in the instrument cluster.
- The vehicle cannot be locked.
-- Turn on the ignition, shift the selector lever into the "P" position.
-- Turn off the ignition.
- The vehicle can be locked.
If the specified values are not obtained:
-- Perform Guided Fault Finding using the Vehicle Diagnostic Tester.
-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .
-- Locking button on selector lever handle, checking. Refer to 4. Selector Lever Handle Locking Button, Checking .