LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 565 (Controls & Housing - S TRONIC Transmission 0B5 (Sedan)) >> 34 Controls, Housing >> MECHATRONIC >> Oil Pan, Removing And Installing >> Removing

Oil Pan, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Refer to GENERAL REPAIR INFORMATION .

Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

-- If equipped, remove the left and right crossmember. Refer to OVERVIEW - SUBFRAME .

Fig 1: Identifying Clamping Sleeve
GWWA40-10125Courtesy of AUDI OF AMERICA, LLC

-- Remove the subframe crossbrace. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING .

Fig 2: Identifying Subframe Crossbrace
GWWA10-10860Courtesy of AUDI OF AMERICA, LLC
CAUTION:

The suspension components could be damaged.

  • Do not rest the vehicle on its wheels if the subframe mount, the steering gear or the subframe crossbrace are not installed correctly.

-- Drain the ATF. Refer to ATF, DRAINING AND FILLING .

CAUTION:

Danger of causing damage to the transmission.

  • Do not start the engine when there is no ATF in the transmission.

-- Diagonally loosen the bolts -1 through 15-.

Fig 3: Locating ATF Oil Pan And Bolt
GWWA34-10429Courtesy of AUDI OF AMERICA, LLC

-- Remove the ATF oil pan.

NOTE:

Ignore -arrows-.

scientia non olet · About LEMON Manuals