MECHATRONIC, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2018 Audi S6, 2017 Audi S6, 2016 Audi S6, 2016 Audi S4, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

CAUTION:

There is a risk of destroying the TCM (Mechatronic) with electrostatic discharge.

Always "discharge" the static electricity before working with electric connectors. Do this by touching a grounded object, for example vehicle GND, the vehicle or the hoist.
Do not touch contacts in transmission connector with hands.

-- Make sure the connector is correctly connected to the Mechatronic.

-- Observe measures after connecting the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Install the ATF suction filter. Refer to ATF FILTER, REMOVING AND INSTALLING .

-- Install the ATF pan. Refer to OIL PAN, REMOVING AND INSTALLING .

-- Fill the ATF. Refer to ATF LEVEL, CHECKING .

After replacing the DSG Transmission Mechatronic -J743-, the corresponding "Guided Functions " must be performed with the Vehicle Diagnostic Tester. Refer to TRANSMISSION GUIDED FUNCTIONS .